Interested to Buy Any Domain ? << Click Here >> for more details...
which is heavier 1kg. of iron or 1kg. of cotton?and why?
- 33 Answers
- 111252 Views
- Getco, Jindal, Lloyd, Naval Academy, NDA, samr, swiggy, I also Faced
- E-Mail Answers
Answer Posted / anurag
Both are same.The mass of each is 1 kg.But 1 important
point the weight of two may not be the same(mg).This is
because as the cotton is porous and can have some air
inside its pores as well as its volume will be
considerable.It will experience an upward buoyant
force.Hence the effective weight=the weight mg(act down)-
the upthrust(act up),which is volume of cotton(net with
pores)*density air*g.
| Is This Answer Correct ? | 95 Yes | 38 No |
Post New Answer View All Answers
Explain the difference between self-energizing and self-locking in brake / clutch.
Assume a DC motor with the following parameters : Motor torque control = 0.0848 Nm/amperes Back EMF control = 0.0848 Volts/(rad/s) Armature resistance = 0.75 Moment of inertia = 0.00001696 kg/m2 With zero frictional load and taking a feed forward gain of 2, determine the motor response for a unit step function. please forwaded the answer to the below mail id thanks in advance Regrads, peer_kaba@yahoo.co.in
What are the advantages of a centrifugal pump over a reciprocating pump?
difference between aerofoil meter and orifice meter
Is the unit and normal value fuel ratio of an average diesel engine?
What is knurling?
What are the minerals needed to make or build a car?
What is the world's hardest metal?
what is the responsibility of assistant manager in welding in goa shipyrad company?
can any one pls refer me any sites which have notes regarding Body-in-white(welding fixtures)...pls
What is blast furnace
HOW TO CALCULTE THE TR CAPACITY FOR SCREW COMPRESSOR, RECIPROCATING COMPRESSOR,PHE & COOLING TOWER? HOW TO CALCULATE THE FLOW RATING OF PUMPS?
What happen when too much cylinder oil is injected in the working cylinder?
What is process flow diagram?
Which material amoung EN8 and EN24 should be selected for the designing of the shafts of rotary kilns
