How to get -10volts DC from 10 volts peak to peak sine
wave?? Design the circuit??
Answer Posted / joby sekhar
10 V peak to peak sine wave sent through full wave bridge
rectifier and use PIE filter for getting pure DC and give
grounding to positive supply ,you will get -10V DC.
Regards,
Joby.
Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
Explain what is a truth table?
What are the applications of dc chopper?
i want aftek placement paper if any body have pls send me its urgent
flow chart to convert binary number into decimal
send me jto(telecom) exam papers
Explain how the active power factor correction changes the wave shape of current drawn by a load to improve the power factor?
What is the approximate cost of the corrosion penetration monitoring system(cpmp)?
State the differences between a flip-flop and a latch?
what would be main different environment in gsm and cdma core networking side?
Define drift current in a semiconductor.
why are u hiring electronics
what is the minimum and maximam trace width in PCB design? why trace is measured in mils? what is the use of via? why the crystal oscillator is placed near chip?
What do you mean by effect of noise on carrier signal & what is noise segment
y do v use single anteena in radar any other reason except cost???
What do you mean by a grounded load?