1.why is +1+1=+2 why cant it be +3
2.Why is +1*-1=-1 why cant it be something else
3.why are the hilly areas more cooler than the ordinary
areas?
- 5 Answers
- 6319 Views
- ThyssenKrupp, I also Faced
- E-Mail Answers
Answer Posted / ajit g. k.
My question-How did this question come under electrical
engineering?
Well, I support the answer of Mr. Tarun Agarwal as a reply
to your first set of queries, but for the second query
about the hill station temperature, here is the answer-
Solar heat is collected by all surfaces at almost the same
time. After the heat collection comes the dissipation, or
reflection in the sense. in hilly areas, the area is more
convex. so, the area exposed to the atmosphere is more.
Hence, heat is distributed to a larger amount of air.
Whereas in low lying areas, the land is mode concave, there
is less exposure to atmosphere.So, the heat is dissipated
and distributed to a smaller amount of atmosphere, thus
heating up the area.
This is why we have more temperature in low lying areas
than in hill stations.
Hope my answer is precise enough to please ur (rather
eccentric)common sense. And the next time, kindly post ur
questions in the concerned branches, and please, stop doing
this...
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
How to work E.L.C.B and how to connect in circuit.
The shot circuit in any winding of transformer result? Explain
How to design the earth grid for lightning protection in an industry
What is the basis for framing the rules of block diagram reduction technique?
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
how to deside the capacity of chock for drive?
What is open delta Xformer? It's adavntages & Use?
what is ic 01,ic 06 ?is it types of cooling?
What is routh hurwitz stability criterion?
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
Can you explain about TEE protection scheme?
what is the difference between gas group b and gas group c electrical equipment construction wise?
what is meant by directional earth fault and non directional earth fault? describe both.
anyone please send transformer parameter design formulas & details of tap changer ? plz i have interview this week its more helpful for me ?
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
