why contactors are used ...? is contactors and relays are
same ...?
- 5 Answers
- 10061 Views
- I also Faced
- E-Mail Answers
Answer Posted / khajamian
Contactors are devices consists of E shaped
electromagnectic core with winding are mainly used for NO
and NC connections which means making and braking of
circuit... we can split the flow of current by using
contactors...DC contactors and ac contactors are also
available.. it is used for high rating ... above 110v ac
and dc... But relays are also used for NO and NC changes
i.e making and breaking of circuits but especially for
remote or distant operation.. using 110 v ac supply..it
also consists of coil but absence of electromagnetic core..
there are several types of relays ..ex: industrial relay,
electromagnetic relay... etc
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
why they were using TRIAC instead relay in some controllers and what is the advantages.
What is earth?
what is the difference between droop mode and ischnorous mode in thermal powerplant?
how much UPS neutral erath leakage current.
At what factor resistance r of a conductor depends?
What is effect of over voltage and under voltage on ACB
How to operate a ac chilar plant?
For R-L or R-C ckt,time constant formula is L/R and RC respectively and its unit is in sec.Pls tell me the derivation
What are the components connected in between the power supply coming from an electric pole to HT & LT Panels in a large commercial building or how the power supply connected from Electric pole to Transformer & then to the HT & LT panels of a building? Please send me answers via mail, my id is yogiagarwal@gmail.com. If possible, please give a line diagram.
wheather the size of windings in motor and generator are the same
what is dry and wet frequency withstand voltage? why & where it is used??
what is size of 3phase 4wire cable to be used for 11 ton ductable A.C and how to calculate cable size for different load
HOW TO DESIGN THE body EARTH cable(Copper Conductor) size for 60KVA UPS?
how is the incoming cable size calculated for a given current rating of a panel??
What are the differences between single phase and three phase?
