What is vector group? What is meant by DYN11?Why is it needed?
Answer Posted / strateia
The Dyn11 is interpreted as follows:
D-primary winding is delta connected (i.e the three primary
phase windings within the transformer)
y-the secondary winding is delta connected
11-is a multiplying factor for the phase displacement
between the primary and secondary voltages
i.e. for the Dyn11, phase displacement is
= 11*30degrees
= 330 degrees
| Is This Answer Correct ? | 10 Yes | 31 No |
Post New Answer View All Answers
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
How to calculate or formula to calculate rhe power in 2 phase system ??
Dear sir, I completed DECE In the year 1995.Now i am working in a private company from last 10 years as an Electrical supervisor.The company having a 1000 KVA transformer.Now i try to apply "C" Licence. I am eligible or not.If not eligible,pls give solution.
Why Utility Distribution System in India is mainly at 11 kV? Why not Utility go for 33 kV?
Whata are the types of Cables?
what is the main difference between power devices and signal devices
orifice sizing how done, checking & selection
what is harmonics? what are the factors it will depend upon
does any one know where we can purchase insulation oil for high voltage oil filled cables
How we calculate the current carrying capacity of H.T. cabel?
HI....HOW CAN BE MESARED THE VALVE OF NEUTRAL GROUND RESISTOR WHIC IS LOCATED AT SWICHGEAR ON GENERATOR SIDE....
Why reactors use before incoming of ac vvfd drive?
What is PEC??Applications........
how mass curve differs from hydrograph.
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?