Interested to Buy Any Domain ? << Click Here >> for more details...
what is the reason of battery voltage is 12v maintain?please
answer me.mail-psrinivasan20@yahoo.com
- 1 Answers
- 5283 Views
- CTS, I also Faced
- E-Mail Answers
Answer Posted / aer
The Lead Acid battery is made up of plates, lead, and lead
oxide (various other elements are used to change density,
hardness, porosity, etc.) with a 35% sulfuric acid and 65%
water solution. This solution is called electrolyte, which
causes a chemical reaction that produce electrons. When you
test a battery with a hydrometer, you are measuring the
amount of sulfuric acid in the electrolyte. If your reading
is low, that means the chemistry that makes electrons is
lacking. So where did the sulfur go? It is resting on the
battery plates and when you recharge the battery, the
sulfur returns to the electrolyte.
Safety
Battery types, Deep Cycle and Starting
Wet Cell, Gel-Cell and Absorbed Glass Mat (AGM)
CCA, CA, AH and RC; what's that all about?
Battery Maintenance
Battery Testing
Selecting and Buying a New Battery
Battery Life and Performance
Battery Charging
Battery Do's
Battery Don'ts
1. We must think safety when we are working around and with
batteries. Remove all jewelry. After all you don't want to
melt your watchband while you are wearing the watch. The
hydrogen gas that batteries make when charging is very
explosive. We have seen several instances of batteries
blowing up and drenching everything in sulfuric acid. That
is no fun, and would have been a good time to use those
safety goggles that are hanging on the wall. Heck, just
break out your disco outfit. Polyester is not affected by
Sulfuric Acid, but anything with cotton will be eaten up.
If you do not feel the need to make a fashion statement
just wear junk clothes, after all Polyester is still out of
style. When doing electrical work on vehicles it is best to
disconnect the ground cable. Just remember you are messing
with corrosive acid, explosive gases and 100's amps of
electrical current.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What is the necessary condition for stability.
how to test and calculat the head and discharge in borewell compressor
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
I want to know how to calculate the size of electricity cable in building?
for compensate 315mh inductance ,how many capaciance required?
defination of controlled shunt reactor
A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.
How to calculate energy stored in a capacitance
Can you explain about TEE protection scheme?
earth also having a gravitational force (magnetic field of north and south)but it attracts any object compare to this theartifical magnetic cant perform same as earth why?
What is the effect of pi controller on the system performance?
How the circuit breaker is selected for Induction motor of 100 kW, 415 volt, 0.85 power factor, 0.95 efficiency ?
how could we know the size of cable by physical view?
How to use earthing on shipments.
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
