Interested to Buy Any Domain ? << Click Here >> for more details...
Though transformer consist winding which usually cause
reactive power change in both generator and motor but it
wont affect reactive power passing through transformer why?
- 2 Answers
- 5279 Views
- Jindal, Reliance, I also Faced
- E-Mail Answers
Answer Posted / vijendra joglekar
The questions itself wrong because the transformer doesnt
consumes real power because there is no rotating part in it
it only introduce working flux but if you take the
generator or motor it will consumes the real power
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
hi every body i am master student in control engineering and my project is slip control in trains i assumed a Dc motore as traction motor but i don't have characteristics of this kind of motor that is used in train. i want from every body if he or she has the characteristics or information about Dc motor that is used in train give me those information or technical characteristics .
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
In radial network the source is fed from 1 end both ends at central
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
what are the advantages and disadvantages of oil filled cables over XLPE cables
what is the difference between torque induced and torque load?compare them with respect to dc motor?
Why is better to have a minimum ceiling voltage of 250% than 160%?
What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?
In a flange coupling, the flange bolts are designed for
what is through fault?
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
What is the exact formula for one weber of magnetic flux?
why servomotor motor? where i apply for best output?
substation+ plc system
how can you calculate fault level ?
