Interested to Buy Any Domain ? << Click Here >> for more details...
How one can check the faulty capacitor, diode when
connected in the circuit ? and when you can not take them
out ?
- 4 Answers
- 10271 Views
- I also Faced
- E-Mail Answers
Answer Posted / gokulkrish
capacitor is checked by continuity test.if failed means its
short circuit.
diode checked by voltage across the terminal.in normal
caseforward bias voltage is 0.7&reverse bias voltage is 0.2v
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
Installation method of self treated earth electrode.
What is Bolted fault?
What is the basic rule for block diagram reduction technique?
star delta starter contorl circuit... drawing..
What is superposition theorem?
What are PLC leader logic program method
in 6.6 kv vaccum circuit breaker vaccum bottole vaccum capacity ????
how do u gauge the size of the cable ?for eg. consider a 300 sqmm L.T Cable.How do u determine the size of the cable seeing it pratically?
write a c++ code that receives an integer number and display the sum of the number and its revers integer?
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
What are the parts in a inverter?
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
