HOW TO CONVERT SQ MM OF A CABLE TO DIAMETER, EG. CABLE SIZE IS
185SQ.MM WHAT IS THE DIA OF THE CABLE??????????????
- 3 Answers
- 50673 Views
- Parsons, SWAN, I also Faced
- E-Mail Answers
Answer Posted / melwyn dsilva
x=pie*r2
wherex=185
185=3.142*r2
r2=185/3.142
r2=58.9
r=7.7
then dia=15.4
| Is This Answer Correct ? | 83 Yes | 40 No |
Post New Answer View All Answers
please anybody help me to find out the BHEL trainee Exam previous year questions papers . if u ve pls. send it to surekhared@gmail.com
How to decide CT & PT ratings for a given transmission line carrying some rated voltage?
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
how to conduct dc resistance test for rotor of an alternator and how to measure the rotor dc resistance value theoritically?
What is the formula to find out two phase active & reactive power
How is magnetic leakage reduced?
Why star delta starter is preferred with induction motor?
in basic 2 phase will short means tripping the power but spot welding 2 phase shorting but not tripping it will welded why.....(Q)
What is force on parallel conductors ?
what's the requirement of Dy11d0 connection of 3 phase transformer?what's use of it?
what questions are asked in the interview for the post of an electrical maintenance engineer in FMCG companies?
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
What is the resonant peak?
