Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / saumya ranjan dash
Answer The law that the stress within a solid
is directly proportional to the strain that the solid
exhibits . Hooke's law in simple terms says that strain is
directly proportional to stress. Mathematically, Hooke's law
states that F=-KX,
Where x is the displacement of the end of the spring from its
equilibrium position (in SI units: "m"); F is the restoring
force exerted by the material (in SI units: "N"); and k is
the force constant (or spring constant) (in SI units: "N•m-1"
or "kgs-2").
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
where proximity sensor installed on tank in loading arm application
How will you test a transistor with a multimeter?
selection of the zener barrier for the hazardeous area zone 0
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
what is the diffrence between pressure safety valve & pressure relief valve....pls
what is wave length were using ?
What are the uses of orifice plates?
what is moisture probe? What are there types? What is there working principle and how they works? guys this is one of technical question I had ask in interview. If you know its answer please let me know. The interviewers were more interested in microwave moisture probe, so if you find its any link please just forward me on my mail id.avinash1200@gmail.com Thanks in advance.
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
What is rang ability?
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
What is the use of double seated valve?
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
