Answer Posted / raj kushwaha
If star connection than Neutral voltage is zero in normal
circuit. But if unbalance load than Neutral currant can not
be zero.
Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
The power supplied to a 33microF capacitor from a 120V, 60Hz source will be
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
Why to keep capacitor bank off while generator running.
why did youi choose this career?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
What is meant by system?
what is the relation between knowing of the distance between power transformer and the capacitor feeder in case of parallel operation
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
What are the Full Forms of TVM, MTL, CVT ?
Define bibo stability.
What is safety of Ht panel
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
State the formula for overall efficiency of thermal power station
How PADO software increase the efficiency of power plant?