What is the typical data rate for wavelength division
multiplexing?
Answer Posted / lodhi
about 600Mbps...
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is the minimum and maximam trace width in PCB design? why trace is measured in mils? what is the use of via? why the crystal oscillator is placed near chip?
can i get the 2007-2009 question papers of APGENCO? plzzzzzz
What is potential transformers?
Do u any one having Idea on Indocen Electronics. That is in Mumbai. I got an offer from that. Is that company is good or not. I am little bit confused on it. Please provide me the information.
Explain the operation of 3φ bridge inverter for 1200 degree mode of operation with aid of relevant phase and line voltage waveforms?
Define diffusion current in a semiconductor.
can i give the short discription to "window size" , "Time out" "piggybacking" in sliding window flow control.
explain with a suitable diagram how a vidicon pick-up tube is employed in a monochrome TV camera to develop luminance signal
Sir, Plz send the last 5 yrs ques papers for Railway board's section engineer post. Thanks, c_k_chand@yahoo.co.in
What are the important ic technologies used?
what is an inverting amplifier?
State the disadvantage of a 8-4-2-1 code.
What do you mean by effect of noise on carrier signal & what is noise segment
What is cache coherency and snooping
pls send me the syllabus questions on rrb section engineer (telecom)