Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / muzamil hussain
High rupturing capacity
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is mathed of check the D.C MOTOR 181 KW (ARMATURE AND FIELD) WHAT IS THE MATHED OF CHECK THE THYRISTOR MODULE (HIGH CURRENT)
Ceiling Fan and Storage type water heater. Discuss
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
wht is embedded systems? what is new inthis field?
How to calculate the input cable rating for 10kva ups (3phase input and single phase output and also 3phase output, battery rating 65Ah)provide the formula also.thnx
what are the main applications of transistor in non-linear region?
what is earthing transformer? draw the winding dia.of earthing transformer.
What is a advantage of Self Reset Lockout ? On Fault breaker get trip & fault no longer exist then self reset lockout how inform us?
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
Why does increasing the magnetic flux in the main field of a d.c motor cause the armature current to reduce??
What is EHT tariff or Power factor Tariff ????
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
what is the standard duration after failure EB power
why the making current is more than then the breaking current and if its true then its about a controling circuit or breaker power contact points
What is mean by hot and cold loop testing? What is the difference between them?
