Interested to Buy Any Domain ? << Click Here >> for more details...
if the 10 hp motor name plate indicates rated current as
13.6 amp the what will be the thermal relay setting?
Why? And in how much time relay will trip at the set
value?
- 2 Answers
- 5909 Views
- I also Faced
- E-Mail Answers
Answer Posted / mahesh solanki
the relay range selected shall include motor i curating.
relay should be set at 90% of FLC i.e at 12.24 A
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
How much voltage we need to apply in 33kv cable during hipot test of cable
What is the disadventage of gland earthing(power cable) if any. ?
How to calculate of maximum demand if given 628kw, 785kva, 0.8 p.f.
During Testing of Maintenance Free Earthing, How deep should be the Spikes of Earth Test Meter should be inserted in the soil(one spike is 15 Meter & Other spike is 30 Mtrs away from the Main Earth Electrode. Because, recently, we observed that when spike is inserted 3-4 Inch in the earth- results are better, If spike is inserted 1 feet deep than results are increasing.
State angle criterion.
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
which pump used in WTP explain the function of VFD how to dtermine capacitorbank of capacity one plant
is it possible to have dc motors on single chip
What are the different circuits in thermal power plant?
How much ph is maintained of water resistance starter for slipring induction motor ?
What are the advantages of using distance protection schemes as opposed to normal overcurrent/ earth fault protection on high voltage feeders.
what is the advantages of having in-built acvvvf (without seperate inverter in the control panel)in the drive system of elevators?
What is the distance between body earthing and neutral earthing.?
What is the best thing to protect the motor from running over full current. CT or O/L or pressure transducer at the given pressure rating
Is there any abbrevation for STUB in Stub bus protection
