Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / aashish
Step:
1.Define objective e.g. if temperature of heater goes
beyond 200 degree celcius the fan made on untill
temperature reaches 150degree celcious.
2. then the given objective is converted in programm by
using set of instruction it may be Plc programming language
s5 or s7 in Ladder logic or STL
3. install program into plc using required input from
module.
4.then start plc it works as per instruction.
5.Requred to connect plc output to field contactar,
6.connect sensor feedback to plc system.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
in valve is constructed as per SME B 16.34, then which standard is used for fire testing of valve?.
How earthing can be checked????
what diffrence b/w plc s7200,300,400
can you send remote seal interface level transmitter calculation steps for oil water saperator.
How oil line flow measured?eplain about instruments used and working principle?
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
Why mmwc unit is used?
How INtools is useful for routine Instrument maintenance?
in mass flow meter what is drive friquancy ?
any body please send me the old question papers of ongc test.
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
Sir, I want junior executive, Instrumentation question papaer for IOCL, Plz send to arabinda.ghosh83@gmail.com
What are different types of orifice plates? State their uses.
what is the difference between -24 : +24 & 0:24 and where it use?
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
