Interested to Buy Any Domain ? << Click Here >> for more details...
In short transmission line,why does the receiving end
voltage is less than sending end voltage?
- 4 Answers
- 7278 Views
- I also Faced
- E-Mail Answers
Answer Posted / samraj
R= PL/A
P-specific resistance of the conductor
L- Length of the conductor
A- area of the conductor
since length is directly proportional to resistance the
receiving end voltage is less
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What are the specifications for conducting earth leakage test as per IEC standard?
Why back emf used for a dc motor? Highlight its significance.
why T/F winding temp measurement cts are odd secondary current ie,109A/1.2A/1.4A?
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
What is the fault or needs to be done when frequency in ac drives is not changing?
what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..
i want to know about torque of slip ring induction motor
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
What is super thermal power plant? and how it will differ from normal thermal power plant
how to find the torque of the single phase synchronous motor by doing an experiment
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
Why compensation is necessary in feedback control system?
SIR, GIVE ME OPGW SAG CALCULATION FORMULA I AM DAE ELECTRICAL. THANKS
how is the cable tray designed & how its total length is calculated for an Industrial plant Say for Ex. (500KW Motor Load)
What is meant by a stray loss of a induction motor??? What is the equation to find it
