Interested to Buy Any Domain ? << Click Here >> for more details...
why we used for range in pnumatic 3-15 psi and current 4-20
ma?
- 11 Answers
- 42324 Views
- Jindal, I also Faced
- E-Mail Answers
Answer Posted / mdshafiullakhan
why we should use for range in 3-15 psi and 4-20ma because
the linearity curve will starts from 4-20ma only during this
source range only we will get the linearised output that is
the reason and 0.22 psi to 1 kg the process will begins from
0.22 to 1 kg
| Is This Answer Correct ? | 8 Yes | 23 No |
Post New Answer View All Answers
Which type of pressure can be measured by these elements?
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?
how many type of plug are used in pneumatic control valve,name them.
What is the diffrence between ff tx and non ff tx
Why mixer nd grinder Is example of constant torque load not variable torque load ???
What is mean by analytical instrumentation?
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
how can use ram
Why boiler chimney area oxyden sensor fixing?
Why plc require in analog input 4-20amp & 0-10 volt?
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
why we use cascade control and feed foreword control in 3 element control of boiler drum ?what is feed forward and cascade control system ?
Manipulation of dead wt. tester double piston type.
