why earth hole size is biggest in plug point?
Answer Posted / kundan malani
R = row L/A.......(1)
r is increase so the a is decrease so the depend to this
equation 1
Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
Is it possible to implement Restricted Earth Fault protection for a transformer without neutral CT?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
tell me about eletrical contractor
How shall i select the value of capacitor or inductor in a system?
How to select circuit breakers rating eg. if i select a circuit breakers of capacity 40 amps DC with operating voltage 28 volts and if i what to use same circuit breakers for 300 Volts DC application what is the current rating of this circuit breakers.
what is Insulation monitoring device. where it is used? (in switchgear room or control panel or in field equipment)
some basic standard questions on transformer.
what is the differences between microprocessor and general purpose computer
Hello seniors m an engineering student in 3rd yr..i want to know what are the software course in electrical field?i wanted to do certification course but i dont know much about the course?..Regards
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
What are the essential characteristics of signal flow graphs?
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?
the problem faced on star or delta winding connection??
What are the causes for the failures of sandwich type (Al) busducts?
What is step signal?