What happen if LV supply is fed to a HT motor?
- 19 Answers
- 41555 Views
- ITC Infotech, Jindal, I also Faced
- E-Mail Answers
Answer Posted / vinodkumar
motor will not run or will run at low speed
| Is This Answer Correct ? | 15 Yes | 4 No |
Post New Answer View All Answers
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
Why Transformer Neutral having one earth pit ( more earth electrode resistance) whereas body have many earth pit ( less earth electrode resistance)?
how to minimize earth resistance upto 2Ω, if the resistance is 6 Ω ?
what is KSR type transmission tower? What is LSR type transmission tower?
WHY SEPARATELY EXCITED MACHINE NEEDS EXCITATION BY DC SUPPLY WHY NOT BY AC
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
What is difference between Harmonic and Non harmonic Capacitor Bank?
Can 4pole (3 phase+neautral )RCCB proper functioning in only 3 phase load (no neautral, no Earth) ?
i am trying to PSUs/govermeant jobs since last 2 years but still i m not success, plz help me.
Do inductive loads have distorted current waveforms ?
100 MVA 3-phase alternator with earthed neutral has a reactance of 5 ohms per phase. what will be the fault MVA of generator.
How to reduce -234126219.6403 MVAr generation and by what?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
Where is servomechanism used?
