Interested to Buy Any Domain ? << Click Here >> for more details...
Will MCB tripped off, if there is an electric shock to
Human body?
- 9 Answers
- 13839 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.mani kandan
no because it trips only short circuit and over
loaded.......
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
how to calculate the surge level of surge suppressors related to the SF6 cicuit breakers?
how does it help for selection of a transformer.
what are the factors to be considered while design the breaker either HT or LT??
how to calculate mf when meter and cTPT detail are given
How can I known multiplying factor .without multiplying table
what is self capacitance of inductor
Block diagram of Power line communication?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
What is diversity factor in electric installations?
what about the power of wattmeter at starting and loding?
If a high resistance fault occurs,then what are the changes will happen in the system?
Explain the operation of variable frequency transformer?
why do we lay up the core of a cable?
is it value of power factor is more than unit. whats effects in the source supply
