Interested to Buy Any Domain ? << Click Here >> for more details...
In 8086 why even address location takes two bus cycles
whereas odd address location takes only one bus cycle??
- 2 Answers
- 11804 Views
- I also Faced
- E-Mail Answers
Answer Posted / dhaval pipalia
The 8086 takes two cycles to fetch words from an odd address
because the Bus Interface Unit (BIU) actually only deals
with words, which are two bytes at an even address.
If you perform an operation on a byte, the BIU will do a
word operation, but it will leave the other byte alone.
If you perform a word operation at an even address, the BIU
can do the operation in one cycle.
If the word, however, is at an odd address, the BIU must use
two cycles, leaving the respective "other" byte alone in
each case. For performance sake, always align your data with
the bus design.
| Is This Answer Correct ? | 22 Yes | 9 No |
Post New Answer View All Answers
Pl. Brief about DNC.
Suppose you have been asked to design one electronic circuit then starting from basic what procedure do you follow?It should include all standard industrial measures. Please reply.Thanks.
I've an interview for post of Lecturer in a ece Department. Can anyone send me some possible questions that can be helpful for me???????
what is the minimum and maximam trace width in PCB design? why trace is measured in mils? what is the use of via? why the crystal oscillator is placed near chip?
In Traffic Manager, What is the Use for Zero (0) timeslot.
What is the purpose of using data modem.
Explain the approximate cost of the smart pebbles eci-1(embedded corrosion instrument)?
What is race around condition in a jk flipflop? How it can be avoided?
plz give the question about interview to the post JR.Executive (ATC)
What are the uses of memristor?
6. When Abis link is down, name the alarm that is generated at BSC
what is the output differentiator and integrator?
Draw the frequency response of DARLINGTON PAIR
What is a diagnostic system check?
Why collector is made larger than emitter and base?
