How are calculated the aluminium busbar cross section area?
- 2 Answers
- 8501 Views
- I also Faced
- E-Mail Answers
Answer Posted / james bond
Area is simply width*depth,,hahaahah
if u dont know the length of busbar answer no. one fails..
simply u have to calculate the Area of bus bar required for
the given current rating or load kW, which is given in IS
standard.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
Starting times for soft starter & power factor is thier any standard or datas available in manufactures list. Kindly suggest.
could you measure current in parallel?
what is the relation between knowing of the distance between power transformer and the capacitor feeder in case of parallel operation
dc supply given to dc generator winding.how is possible? my knowledge is saying the winding will burn. please reply.
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
What are IP protections used for electrical panels, JB, equipments installed in explosive zones like Petrochemicals, Oil & gas
1. for eg, capacitor is used for many purposes(it act as filter, oscillator, bypass capacitor, memory storage etc...) 2. Please tell me some example circuits for different uses of capacitor( whenever and whereever and however we used capacitor as a filter, oscillator tuning etc..) 3. similarly for inductor and resistors(it act as what?) and when and how we want to act as like that?, and how we can used these components depends upon our requirments with example circuits and explanation? design to act as these components depends
What is trip and closing coil in cb? Why need of them
How we calculate DC inducation moter Amp? Sir pls give me formula......
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
What is the permissible maximum flux density in transformer core?
what is mppt (maximum power point tracking ) and how they used in solar power generation ??? what are the main components used in mppt?????
what is LSR?
Use of switch mode power converter in real-time basis?
can anyone explain 11kV 3core cable megger,hi pot test procedure with connection details?
