Answer Posted / mohammad sikandar
process control means measuring and controling of process
veriable like
level,pressure,tempreture,flow,vibration,qantity this all
those measure and give to out put to finel control.
Is This Answer Correct ? | 23 Yes | 3 No |
Post New Answer View All Answers
is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?
How to calibrate RC Feeder system in thermal power station?,If any instrument available to calibrate it,ple inform me. make:stock,
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
Difference between ultra sonic flow meter
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
2. What is ultrasonic flowmeter?
What is the difference bitween control net scaner and device net scaner
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
How INtools is useful for routine Instrument maintenance?
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
all questions related to instrument technician in any offshore oil and gas company.
Name different types of bourdon tubes.
what would be the minimum flow rate that we can measure on rotameter..?
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.