Interested to Buy Any Domain ? << Click Here >> for more details...
tell me about Woodward505 Function as a point of Instrument
Engineer.
- 4 Answers
- 12479 Views
- I also Faced
- E-Mail Answers
Answer Posted / ramesh
woodward 505 is the governor for the steam turbine it
controls the inlet steam , speed & extraction steam
generally it having so many options it needs the to rpm
sensors the advance system of 505 is 505E
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
How to find out the current of two motors having same power consumption but different RPM?
the output of the common trasmitter protocol in qatar gas are the following
Can anyone send most commonly asked interview question in Oil & Gas industry
what is the minimum power (P=VI)to produce a spark?
With N nodes and B branches what will have a network ???
Why is the orifice tab provided?
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
give eg of how I/P is used in control loops
i am having information technology branh ....... can i prepare for psu exam
Hello to all....I am an Instrumentation Graduate and i am passed out in this year only.. I am unable to find the job in my core instrumentation.. so any boby tell me how to and where to search the job....please...and also tell me i there are any courses offered in the instrumentation stream so i can do it... you can send your suggestions to my mail-id i.e Ganesh20084u@gmail.com ... please..
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
what is the imbustion control loop
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?
