Interested to Buy Any Domain ? << Click Here >> for more details...
how to select earthing wire? procedures and parameters?
- 2 Answers
- 10374 Views
- I also Faced
- E-Mail Answers
Answer Posted / kathiravan
actually the earth conductor capacity not lees than twice
that of FLC of connected load.In india normally cu and GI
flats are used more than 35kw where as open cu wires and GI
wires.The motto of earthing is that "Human Protection" means
the fault current has to be earthed in safe manner.
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
i am gng to visa interview this july i have 4 backlogs gre 1010,toefl 75,pls give me the tips pls pls
what percent do you derate your copper wire when you change from copper buss to copper wire
How to calculate VCB rating for 33KV ,25 MW Power line?
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
can we find the inductance of a induction motor?
How do we calculate the Out put voltage of generator, after the excitation is being given?
What is the difference between vector surge relay (78) and Pole slip relay (98G)
How can we find out LT UG cable fault (size,from-4*25mm sqr to 4*300mm sqr)? How mani types UG cable faults?
How to determine alternating current frequency?
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
What are approaches to tackle sedimentation problem of reservoir?
What is essential to prove safe isolation of electrical circuit?
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
why dc is used in control circuit for mv & hv switchgear instead of ac
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
