Interested to Buy Any Domain ? << Click Here >> for more details...
what are the differences between MCB and MCCB ?
- 19 Answers
- 42809 Views
- Bhel, DLF, Omax, I also Faced
- E-Mail Answers
Answer Posted / subir kumar manna
MCB is a small type of mains power operator , thats
function is miniature cirquite breaker. overload protection
short circquite protection. there cappacityes is low current
carrieng capacityes .
MCCB that is a moulded case cirquite breaker, internaly
function of mccb any hunting trip and under voltage realese
over load realese , short cirquite realese , earth foult rea
lese . mccb is a large current carring capacities .
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
which pump used in WTP explain the function of VFD how to dtermine capacitorbank of capacity one plant
what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing
What are the advantages of nichols chart?
how i can calculate the size for fire cable
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
are there rmu for 3 transformer?
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
How much kv gas generator is needed to run 2 hp and 1 hp airconditioners, plus a refrigerator and 4 Tvs
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
what is vtg limit of earth and neutral at transformer side?
What is the meaning of utility ground and clean ground? How the distribution panel is grounded?
What is the distance between each insulator in 33kv transformer and how can it calculate
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
Can any one know what are the symbols at the down (below) the analog ammeter??? there are 4 symbols which are they ?????
What will be the output voltage of a transformer if it is primarily energized from a square wave voltage source?
