Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kartik
the device which is used 4 to hold the tool during a
working so the quality of the job is increased because of
the tool does not get a freely movement during the
machining process.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is a torque converter?
why screw pump are used insteed of centrifugal pump?
Why would you use pneumatics?
Name the welding tools used in workshop?
For hot water : please compare to solar heat and heat pump (environment/operation/invest...) Is there any comparison available. Thank you
if the blade height is increased,then how it increases the specific speed of centrifugal pump?
Where can you find space heater lam p and what is its purpose?
What is the microstructure content of D25-8 nodular cast iron?
What is the trunk type and crosshead type piston
type of welding
pls tell me the process to set up a power plant right from the permission from state govt ????
I got i20 for university of bridgeport,university of new heaven and eastern michigan university.Please tell me visa success rate for these universities.And I want to go to Connecticut.At that place two universities are avaliable one is new heaven and the another one is bridgeport.Which is the best? Please give reply as early as possible.
How much pressure on air reservoir?
What is ferrite?
Please mail me the Satyam Computers (Mechanical Division, Satyam Technologies, Hyderabad & Bangalore) question papers on Design & strength of materials. Will be very thanksful.....srinivas_1704@yahoo.co.in
