Answer Posted / om
Mainly three types of welding (Arc welding, Gas welding and
Resistance welding).
| Is This Answer Correct ? | 11 Yes | 5 No |
Post New Answer View All Answers
What is the cause of cylindrical liner overheating?
Hindustan petroleum placement papers.please send me.
What are steam turbine parts usually come into damage?
What is meant by newtonion and non-newtonion fluids?
Metals, in general are of low strength and do not possess required physio-chemical and technological properties for a definite purpose. Alloys are therefore more than metals alone. Discuss the arrangement of atoms and structures of alloys.
What are the causes of L.O. high temperature?
why stress relieving of stainless steel is not preffered
interview questiions for production planning
What are the things needed to have an efficient boiler burning?
What are the causes if one cylinder in a diesel engine has a high temperature?
How much is the work done in isochoric process ?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
How to Start Boiler Electrical Feed Pump? I mean to How to Charge it?
design of a dust collector?
how to success for interview
