Interested to Buy Any Domain ? << Click Here >> for more details...
Why all voltage levels are the multiples of 11KV?
- 10 Answers
- 54113 Views
- KSEB, I also Faced
- E-Mail Answers
Answer Posted / ranjith
because output equation of transformer depend upon
formfactor so it is in multiples of 11
| Is This Answer Correct ? | 2 Yes | 15 No |
Post New Answer View All Answers
Hi, This is Laila. I am selected for syndicate bank interview. Could you please share your views and the questions asked if you have faced the interview My email id is laila_honey09@yahoo.com Please send as fast as u can.Thank You Thanks... Laila.
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
how we design a pannel to start 10HP motor with the help of star delta starter?
I am a electrical engg. diploma holder,applied for junior engineer (electrical),Kolkata RRB. Have I to attend all electrical,mechanical&civil portion in written exam.???
How to select circuit breakers rating eg. if i select a circuit breakers of capacity 40 amps DC with operating voltage 28 volts and if i what to use same circuit breakers for 300 Volts DC application what is the current rating of this circuit breakers.
1.why are not using acb 33kv ht side? is there any problem 2.what is difference between acb,vcb,sf6 breackers? 3.what is the function of invertor and convertor in ups?
what is excitation/
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
Single phase and threephase power calculation
Define steady state error.
How is magnetic leakage reduced?
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
what is the main function of capacitors in mccs.
