Answer Posted / manraj
it is just atmospheric temperature which r present at the
time.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
How to measure the dust in chimney(spm)?
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
How to Calibrate Flammable gas detector in field
Conversions
why we are using drum level control valve air to close?
Which type of pressure can be measured by primary elements?
What is Positive Calibration and Negative Calibration?
Manipulation of dead wt. tester double piston type.
Explain the mechanism behind the turbine meter.
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?