What is the units of surface tension and also dimensional
formula?
Answer Posted / prabhat ranjan
units:-nwwton/length=n/m
dimension:-M1L0T-2
Is This Answer Correct ? | 4 Yes | 5 No |
Post New Answer View All Answers
What is the different types of surge tanks ?
Draw the flow of F.O. diagram from service tank to Main Engine?
What is the difference between EN 8 and SS410 grade material with chemical composition and application.
How much machining cost required for 1000x1000x16Thk(Mild steel)
Why coupling should be located very near to the bearing? Why lap joint not recommended for tensile force?
Explain difference between modulus of resilience and modulus of rigidity ?
Explain the advantages of cycloidal and involute gears?
How would you increase the volume efficiency of centrifugal pump?
my jindal interview is on 24th.. can anyone give me few tips regarding the same? lik how i shud prep
Is copper tube withstand under hard water say as 500 TDS.And is it cleanable by solfamric acid or by tube brushing
Explain how can I see where pipes are behind the wall?
Why do the radiators in your house click when you start the heating system?
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
what is the use of CW(Circulating water ,clarified water,cooling water),auxiliary cooling water(ACW),auxiliary raw cooling water(ARCW)in thermal power plant.plzz explain the different characteristics of these types of water.
What is the most important thing you have achieved as an engineer?