Interested to Buy Any Domain ? << Click Here >> for more details...
i have 20 kw motor & my vfd drive capcity is 18 kw if
possible to use 20kw motor on this vfd?
- 4 Answers
- 9869 Views
- I also Faced
- E-Mail Answers
Answer Posted / sk.raffique
U can Use The 18 kw drive no problem .U are using VFd to
Reduce Power u will not be running for 20 kw if U want to
Use More Than that u increase The Torque setting and torque
%. the problem will besolved .
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
How to check vortex flow meter is in good condition while we do not having calibration setup?
how is work pressure switch& level switch?what is the principle of this?
What types of Instrumentation Related Questions can an Interviewer ask in a Telephonic Interview ?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
what is function of switch, and how is it work, explain with difination
I need to know steps to Calibration Valve Guard......
Explain about safety integrated level protection? . How it was differ from other protections ?
what is loop1 and loop2 in MTS LT?
how can we tune a PID. If it is by zeiger nichols method..please explain briefly with help of an example.
What is the difference bitween control net scaner and device net scaner
the output of the common trasmitter protocol in qatar gas are the following
what is 24vdc live and dry supply
Explain why use mmwc unit?
