Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / anoop
DCS is redundant but PLC is not redundant.
| Is This Answer Correct ? | 1 Yes | 25 No |
Post New Answer View All Answers
any one can send me instrumentation previous interview papers? I prepare for MNC Company Interviews? my mail id- Rakesh.Golla@dodsaldxb.ae , and another mail rakesh.gvk@gmail.com
what is the responsibility of an instrument commissioning supervisor
how to work static pressure sensore how to work dpt
Questions on flow meters,few questions on HART protocol,
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
How to Calibrate Flow Switch in field
How RAL(Rotary air lock)works in cement industry?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What are different types of orifice plates?
How r the calculation of process line mpm.
can u briefly explain aboutan aryton shunt multirange DC ammeter?
Im having problems with interfase betwen SPI v7.0 and SPPID v5.05. Previous versions of Intools shoul be fixed with SPPIDproj.ocx file. It was necessary to replace this file with one that allows the connection between different versions of SPPID. It is necessary in the current version to do the same?Thanks
What is zener diode? What is voltage regulator?
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
