Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / lekhasahithi
it is C14H14S2
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
Mention the disadvantages of low power factor?
What is a fuse? How does it work? What are materials used?
Is better to supply the voltage for static exciter from the auxiliary power source or from the SG terminals? And why?
How to select, design,size & calculate for 11 KV/33KV/66KV/132KV/220 KV/440 KV circuit breaker for HT side of transformer protection/HT distribution protection?
when ac current flows thru d coil of a contactr,it energizes,magnetic field attracts d contact of the coil...nw wont dt ac current in d contct induce current back on to d coil thru mutual inductance leading to high currnt in d coil
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
Why are lt windings placed near the core?
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
Why is tan-delta test and capacitor measurement done on alternator?
can someone explain that how the speed of the protection system affects the fault level calculation?
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
why moisture formation found in XLPE Armoured cable outer sheath
Why are the laminations insulated from each other?
What is the difference between earthing,ground&nutral?
