Interested to Buy Any Domain ? << Click Here >> for more details...
What is the stander resistance value between the neutral and
earth?
- 10 Answers
- 23413 Views
- Crossdomain, Sepco, I also Faced
- E-Mail Answers
Answer Posted / harbhajan
0 to 3 volt
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
How to calculate no of Lighning arrestors are required for protecting 50mX 50m*20m cubical building and locations of LA?
What is effect of harmonic current (Draw by VFD) on power system/ electrical Equipments ?
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
What will happen if the voltage in my house drops from 220V to any lower voltage?
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
How to Design green buildings services? What is the advantage to design green building?
What is the relation between frequency and motor rpm?
EXPLAIN WHY THE SURGE CURRENT RATING OF AN MCCB OR CIRCUIT BREAKER DECREASES WITH INCREASE IN THE RATING OF MCCB OR CIRCUIT BREAKER.
What is the formula to calculate the rating of a three phase air circuit breaker
While testing a ZCT what parameters have to check or measure?
what is star delta starter? how it works? give its control and power diagram.
How many types of electric motors are there?
What are the causes for the failures of sandwich type (Al) busducts?
Why Water motor is not taking a load or pressure while everything is correct. (Note: Motor running properly)
