Why reverse power relay is used?

Answer Posted / sivaraju

if two generators synchronised and are punning parallel,
the total load divided and generator takes half of the
total load upon it.
some times because of load unbalancing one generator
shifts his total load on second generator and run as a
motor . before this condition the generator is taking load
upon him and now it will became as a load and it will run
as a motor insted of generator.
in this condition the second generator winding can be
damage, so we use reverse power relay. because the
direction changed of power , so we called it reverse

Is This Answer Correct ?    7 Yes 6 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

HOW DOES THE ELECTRONIC ENERGY METER WORKS?

1607


what is the purpose of using filters in a protective relaying scheme?

1752


while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?

2417


what is circuit recombiner and how it is different from circuit breaker

1366


What is a fuse? How does it work? What are materials used?

1519






State and define norton’s theorem?

772


Can you explain about TEE protection scheme?

1748


I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?

1772


IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.

1619


what is the transformer turn ratio formula and give some examples?

1920


design a 3 bit synchronous and asynchronous counter using T- flipflop

1568


What is a parabolic signal?

631


What is load boxes ?

1584


why impudance relay used for medium transmission power system? why not others?

911


An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%

1405