how the 2.5bar pressure able to control the 40bar steam
Answer Posted / centhile r mohan
the 2.5 bar is used to control the valve by giving it to
the diaphragm to actuate it.so the process pressure 40bar
is controlled.
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Draw a group of instruments interlocked to a Pump & Motor?
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
PLEASE PROVIDE SAMPLES OF CHEVRON SKILL TESTS
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
What is instrumentation instrumentation engineering?
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
Type of level transmitter commnly used in Procees area are the following. a.________________This type of level transmitter works as follows
I want to know the questions asked in ONGC interview(after being selected in the written exam) for Instrumentation branch.Kindly help.
why we r opening HOT BYPASS valve during startup of a compressor?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
Explain why use mmwc unit?
How ejector(or)evactor air pump is working in thermal power plant?
field bus transmitter calibration procedure tell me
How to Calibrate Interface Level Troll in field