Interested to Buy Any Domain ? << Click Here >> for more details...
In CT's they mentioned 400/5 or 1250/5, 1000/1 here
400,1250,1000 is Breaker Capacity what is the /5 Explain me
briefly
- 2 Answers
- 5599 Views
- I also Faced
- E-Mail Answers
Answer Posted / cnu
CT is used for measuring high currents. even in a circuit
breaker it is used to measure the current and to send the
signal to the relay in case of any abnormality.
the 400/5 on the CT denotes the transformer ratio. that is
when 400Amps flows through the primary of the CT the
secondary of the CT is induced with 5Amps, which is easy
for measurement.
so the fraction on the CT denotes its ration which defines
the value of current flowing in the secondary side.
| Is This Answer Correct ? | 17 Yes | 2 No |
Post New Answer View All Answers
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
Why r u using pf panel. what the uses
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.
i need of the bhel question papers along with answers and also give some website names for the downloading question (electrical and electronics engg question)please help me....
What is the effect of positive feedback on the stability of the systems?
For small size, high frequency coils, the most common core material is- a. )Air b. )Ferrite c.) Powdered ion d.) Steel
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
distribution is maximum done by a)radial b)network c) parallel d)b & c
when 20hp 3 phase motor start no load condition in star or delta connection.find current and write formula.(tariq)
what is difference between 2 pole structure and 4 pole structure in transformer yard
How to select the proper VSD to operate high inertial load
What are the main advantages of bode plot?
how to extend relay operating timing in 24V dc relay card (without using Timer )
what is KSR type transmission tower? What is LSR type transmission tower?
what will happen if frequency is below 50 hz?
