Answer Posted / poorna

i think in all the above mentioned method there is a
disadvantage of motor reversal motor reversal cannot be
easily obtained we have to change the armature or feild
terminals, as magnetic field time const is much high field
reversal is not generally employed, even the reversal of
armature terminal is also not done as it may results in
jerks, so the best way is TO HAVE DUAL CONVERTER TO CONTROL
THE MOTOR IA ALL FOUR QUADRANTS

How will you utilise electrical power? You can start from the generating station.

1862

---

How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke

2023

---

What is resolver and glass scale in CNC how they work?

2231

---

How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?

2060

---

what is vtg limit of earth and neutral at transformer side?

1977

---

what is the usage of microcontroller in the panel board?

2036

---

I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?

1810

---

what is Fault level? why it is calculated? how will u decide same for our plant?

1985

---

In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.

1798

---

what are factors to be consider in electrical installation like load factor,diversity factor .....

1761

---

what the principle of sincroscope?how it works?when it needed?

2246

---

can you plz send l&t aptitude questions if available its urgent plz plz plz

2063

---

How to resolve if Diesel generator stop while running ?

3048

---

WHAT IS THE DIFFERENE IN ACTION OF MCB,MCCB,RCCB

2366

---

what is automatic voltage regulator?we can control the vlotage by using fuzzy controller in matlab?why we go for fuzzy?

1909

---