why HT line voltage is multiple of 11.eg11kva,33kva,132kva
Answer Posted / x
its because form factor of sine wave will be 1.11 alla
voltages will be multiples of 11
Is This Answer Correct ? | 21 Yes | 3 No |
Post New Answer View All Answers
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
What aturn on methods of scr?
What is stepper motor?
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
where rlc series ckt used?
WHAT R THE SAFETIES IN A HIGH TENSION PANEL N LOW TENSION PANEL. ALSO WAT SAFETIES R THERE IN A 200 KVA TRANSFORMER?
what is distribution board?
how we test a 3 phase motor on single phase supply....? HOW WE RUN A 3 PHASE MOTOR ON SNIGLE PHASE. supply for testing..? how we verify of a 3 phase motors 6 wire & name thame a1/a2/a3..b1/b2/b3 and c1/c2/c3 for connecting star delta starter ........i have only 1 phase supply ? help forum..........
L.A. (Lightening Arrester) is located at a place from where transmission line enters the transmitting substation. So L.A. (Lightening Arrester) is the first equipments which has to encounter with lightening, high voltage surges and switching surges. It has to absorb energy of lightening, high voltage surges, and switching surges. L.A. (Lightening Arrester) is made up of layers of semiconductors. If these layers can not tolerate energy released by lightening, high voltage surges, and switching surges the L.A. (Lightening Arrester) blasts.
iam using DM 3251 voltmeter(1 percent accuracy)for 11KV system PT ratio is 11KV/110V.can anybody explain what is the max and min voltage deviation.
Why are lt windings placed near the core?
What happens to a line-frequency of high-frequency transformer when it is first energized/ re-energize?
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0