How to calculate voltage drop loss in HT 11000 Volts XLPE
Aluminium conductor cable. Any specific formula or Thumb
rule
- 2 Answers
- 11507 Views
- I also Faced
- E-Mail Answers
Answer Posted / sunil ulange hit nidasohi
Voltage Drop depends upon various things
1.Resistance of cable
2.Reactanace of cable
3.Length of cable
4.Current Rating cable
5.Grouping factor
6.Underground or in air
7.single or Multi cables
8.Soil Resistivity if underground
9.Temperature
10. Current density
if all above points are provided then only its possible to
calculate voltage drop
| Is This Answer Correct ? | 24 Yes | 4 No |
Post New Answer View All Answers
i have install 750 kva distribution transformer at my site and want to do neutral earthing. what calculations should i follow to determine earthing conductor material and size?
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
what is the Pickup/drop off ratio in BCPU relays
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
how does a submersible pump work..?
what is the calculation formula for motor starting torque,running torque, running torque.
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
WHAT IS THE FORMULA FOR CALCULATING CURRENT RATING(DIRECT IN GROUND OR AIR) OF ARMOURED(XLPE) CABLE OF 4C,16Sqmm?
How to select the earthing transformer,for DELTA TO DELTA TRANSFORMER OR ALTERNATOR SIDE.Pls post your answers and calculation.
Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used
Why efficiency in thermal power plant is low?
why transmission is only 3 phase and not 2 or 4 or poly phases
what is the voltage between earth & neutral in 3 phase electrical connection.
How to calculate Number of Earthing Pits....???
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
