how inductance related to number of turns in a choke
Answer Posted / gurdeep singh
XL= 3.14*F*L*N
Is This Answer Correct ? | 3 Yes | 5 No |
Post New Answer View All Answers
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
how to find Harmonics and types as per the equipemnts
BSNL TTA EXAM QUESTION
What is polar plot?
How can we findout the maximum efficiancy of Transformer? At which load?
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
How can i calculate the Breaking capacity of molded case circuit breaker, is the breaking capacity of CB for Diesel generator shall be less than grid supply's breaker ?
how can maintaince the acb contactor moveing and fixing kit
How to decide whether A / B / C / D curve type MCB should be used?
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
in my industry we are using 3 step up transformers for induction heaters..i.e 415/580v and other are 11/440v.in power consumption does a step trnsformer makes any difference compared to step up?? plz explain
draw 3 phase rectifier diagram
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
what is earthing.how we make it,describe briefly.