Interested to Buy Any Domain ? << Click Here >> for more details...
IN CONTROL SYSTEMS Y WE NEED TO KNOW THE STABILITY OF THE
SYSTEM?WHAT IS ITS PRACTICAL USE?
- 2 Answers
- 8894 Views
- I also Faced
- E-Mail Answers
Answer Posted / john h
Answe #1 is right. you need to know your system will work
and under what conditions and design for them. as
Conditions change so may your system reliability.
For instance AWG can handle a specified current at a given
size but under some conditions this value may need to be
derated. same goes for many components. Nema can often take
more abuse then IFE ( a european standard i can't recall
the name accuratly) as these components are made with less
resources and operate in tighter tolerances. Often but not
always cheaper then NEMA for the same ratings.
This also gets into dirty electrical waveforms and magnetic
flux you do not want a near by conduit accidently inducing
a voltage on a signal line triggering a false or true
conditions. this can bring about changes in your control
system causing erratic behaviour
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
How many kinds of E.L.C.B and how to work E.L.C.B
i want to model paper for section engg.
How may I enrol or get admission to your program?
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
what is the use of commutator in dc motor if we supply ac ? commutator is used to convert ac to dc.and it is used to arrange the flux in unidirectional in case of dc supply. if we give ac as supply to dc motor what is the use of commutator?
How we calculat the NGR of 3phase Generator, Our generation voltage 11KV
In TNC switch, is there any 1NO+1NC block ? and if we move over closing position, is ther any affect on trip position or vice versa?
What are the two basic types of transformers?
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
Define pole pitch?
WHAT IS LOAD CELL
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
What is the difference between grid and off- grid system??
Which standard we are following earthing resistance test
