Interested to Buy Any Domain ? << Click Here >> for more details...
132 KV TRFO BUSHING CT BURNT WHEN A 6.6KV HAS BEEN APPLIED
TO IT .WHY .ANY REASON ?
- 3 Answers
- 7575 Views
- vguard, I also Faced
- E-Mail Answers
Answer Posted / ganesh r
b coz of high current
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
Define norton equivalent circuit?
what is lrs tank water resistance.
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
Why we are use dol starter up to 10 hp
WHY BREAKER ARE USED IN SUBSTATIONS?
Can you any one explain application of buccholz relay operation and pressure relif device operation of power transformer
What is the mechanism of WTI
what is the k var ratting of 1250kva
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
how to store the thunder power?
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
What is method of calculating the fault current for a MDB, 50KW, 3PH, 415V, 50HZ?
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
