How can you justify a fully carged battery by physical
checkup ?
Answer Posted / bhavani prakash
1) By Measuring its VOLTAGE by Multimeter, in case of 12V
battery, it should be between 12V to 14V.
2)By Measuring with HYDROMETER, the SPECIFIC GRAVITY value
should be between 1.19 to 1.4
3) By Measuring the TEMPERATURE that should not exceed
above 41 degree C
In case of VOLTAGE is lower it should be charged with a
CONSTANT CURRENT or CONSTANT VOLTAGE CHARGER to reach the
specific voltage of battery.
In case of SPECIFIC GRAVITY IS LOW, the distilled water
should be added to all the cap holes to certain distances in
the battery and then charged.
If the water and sulphuric acid in the battery turns black
then the battery is dead.
A proper Ventilation should be arranged to limit exceeding
the TEMPERATURE of the battery in charging condition.
The Terminals of the battery should properly cleaned with
PETROLEUM JELLY.
The battery should not be placed under sun light.
It should be cleaned with wet cloth.
For any purpose the battery should not be SHORT CIRCUITED.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
what is meant by brushed alternator & its working principle ?
which type of stability limit is higher,steady state or transient? why?
what is the mechanical safety of DG ?
What current flows in the transformer primary when its secondary is open?
In Generator How suction compression power and exhaust works ?
1.what is difference in maintain Hz again Hz in USA ? 2.how to calculate the battery AH? 3.why are yearly maintained in transformer how many tests in required?
How much kv gas generator is needed to run 2 hp and 1 hp airconditioners, plus a refrigerator and 4 Tvs
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
What is meant by vector group
I need the list of Universities who have summer intake for BS degree in Electrical Engineering.?
what size steel armoured cable is required to support 1500kva capacity. would 70mm squared be enough or would I need 90 or 120mm squared 3c plus earth
can we use trip light with bus coupler?
what is the reactive power what is the use of it in system
How much of the total hydro power potential has been exploited so far in india?
what should be the ideal gauge of wire (In sq mm) for different loads in Ampere?