Answer Posted / dilip
lower part of connecting rod is crank.
| Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
I want to know flow rate,max pressure drop,heat load,design pressure,test presurre,temp both inlet and outlet of coldside and hot side of 1,2,3,5,5.5,7.5,10,12,15 tons
I've been running into situations where a relief valve is being used to protect a regulator. Is this common? And, is this a proper use of a relief valve?
what are the parameters are selected while manufacturing a single cylinder block?what are the different kind of test is conducted on it so that it can withstand with all those condition which required to run the engine efficiently.which force is act when piston slide inside the cylinder.
What is the specific heat of water?
please send me previous placement papers of cummins company
State the function of neck ring in centrifugal pump?
How do you control cylinder liner wear?
working of nuclear power plant
Why centrifugal pump is not called as a positive displacement type of pump?
Differentiate Between High Speed coupling and high torque coupling with examples.
What is the principle of mechanical refrigeration ?
how control valve works? process line pressure is 50kg/cm2g and instrument air pressure is about 4 kg/cm2g.
Explain why will an ice cube placed in a cup of hot rotating water spin automatically faster than the water itself?
Why the work per kg of air flow in axial flow compressor is less compared to centrifugal compressor for same pressure ratio ?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
