what the different types of cables used for 11kv and 33kv
over head work and what is the size of cable in sqmm.
Answer Posted / pavan
The Area of cross-section of a current carrying conductor,
depends upon the amount of current it has to carry.
1 sqmm of aluminium conductor has a capacity of carrying 1
Ampere of current and can be loaded upto 1.5A
1sqmm of Copper conductor has a capacity of carrying 1.2
Ampere of current and can be loaded upto 2.5A
So when Heavy loads are to be transmitted at long distances
we use high voltage so that the current becomes less, there
by decreasing the conductor size, losses etc.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
Why we use mho Relay in long transmission line?
what is the difference between RMS & TRUE RMS VOLTAGE
In PFI plant one stage capacitor connection is directly connected(with out megnetic contact controll). but why?
Why an ac systems are preferred over dc systems?
Comment on the working principle of operation of a single-phase transformer.
How will you justify IR value and Charging voltage of any motor,transformer and Cables.......???? . . . . . . . . Plz tell me any body Baljeet Singh, engineer_89@refiff.com
how generator load test is conducted?what are the steps?
What is a DC series motor?
We need to current density & short circuit calculation at 65kA for aluminium & copper busbar.
What are the causes for the failures of sandwich type (Al) busducts?
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
what is effect of length of air gap on performance of dc motor and generator?
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
what is the use of Auto re-closer?