Interested to Buy Any Domain ? << Click Here >> for more details...
how the 2.5bar pressure able to control the 40bar steam
- 8 Answers
- 11768 Views
- IBM, PAFL, Thirumalai Chemicals, I also Faced
- E-Mail Answers
Answer Posted / ramesh4529
yet to find
| Is This Answer Correct ? | 0 Yes | 6 No |
Post New Answer View All Answers
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
The company where I am working, their is rosemount 5400 series radar type level transmitter, it is meant to show level of filled tank, but along with the level it is showing temperature also, so my question is how a onon-contact type radar type level transmitter can show temperature even if it does not have any contact with the fluid?
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
How we calculate orifice plat size???
What is force balance principle? State some of its’ advantages.
Can combine control system for Emergency control system (ESD)and Fire & Gas System ( F & G) is possble to built and offer to client? Can such system is as per Norms in India?
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
What are the uses of orifice plates?
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
How ejector(or)evactor air pump is working in thermal power plant?
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
how to measure oxygen which methods are using?
for oil & gas industries which zone is normally preferred? why? give its example?
How is work 5/2 sov?
