What are the advantages & disadvantages between analogue &
digital communications?
- 3 Answers
- 17217 Views
- I also Faced
- E-Mail Answers
Answer Posted / sigma 6
Disadvantage: Analog signals are prone to noise and when
lost (fades and blockages etc.)it cannot be recovered
anymore, limited in capacity.
Advantage: Analog signals are true representation of the
original signal, easy to implement, real time transmission.
Disavantage: Digital signals requires high BER reliability
requirements, not real time, difficult to implement.
Advantage: transmission rebustness under adverse
conditions, high capacity, lost informations can be
recovered, higher noise tolerance, complex modulations can
be impelemented easily,multiplexing techniques are easy to
implement.
| Is This Answer Correct ? | 16 Yes | 5 No |
Post New Answer View All Answers
importance of defining tg or tf in selecting master and slave bts's?
can i give the short discription to "window size" , "Time out" "piggybacking" in sliding window flow control.
difference between pre silicon debug and post silicon debug
What is the difference between a multiplexer and encoder? Also what is the between demultiplexer and decoder?
Which of the following protection methods is NOT supported by FlexiHoppers with FIU19(E)?
what are software interrupts present in 8051 Microcontroller? Only Software interrupts//////
why three pick-up tubes are provided in a clour camera?
Write the definition of the duality theorem?
if i get a job in bsc .what are the main key duties to handle
What is a feedback?
State advantage in using microcontroller while designing any system.
I gave interviews for infosys and accenture in my college after which my college said I was selected in infosys. After some days I got a mail from accenture that we have dispatched the offer letter to ur college. I talked to my training officer and he is not ready to give me my letter. So how do i contact them to get my letter online ?
As a water tank loses heat, the temperature drops by 2 K/min when a heater is on, the system gains temperature at 4 K/min. A two-position controller has a 0.5 min control lag and a neutral zone of ± 4% of the setpoint about a setpoint of 323 K. Plot the heater temperature versus time. Find the oscillation period
What is the chemical composition of the substance used as feed horn? And how many types of feedor are there?
Explain how to measure frequency without cro?
