Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate Battery back up time for a 400 AH Battery
bank having a load of 20 Amps and charging time required to
fully charge this battery bank?
- 2 Answers
- 7724 Views
- I also Faced
- E-Mail Answers
Answer Posted / kiran
As battery rating given as 400AH, means 20A*20H or 2A*200H
or 40A* 10H like that u can multiply in any proportion
based on the hours.
As the load is given as 20 amps,so it gives battery back
up of 20 hours,which means 20*20=400AH and battery charging
depends on the battery depth and its efficiency to
charge.........
any suggestions or coments regarding to this answer are
welcome......
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
How to calculate Grid rotor resistance(GRR) losses in slip ring induction motor?
If a transformer primary winding operates at 240v, the secondary at 120v and the load is 1500w & the transformer is rated at 92% efficient, what's the current flowing through the primary winding of the transformer? What is the formula for finding this?
What is CCT (Correlated Color Temperature) ?
Phase control and integral control are used for?
Can you explain about TEE protection scheme?
What is meant by system?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
what is transformor oil gread
What is an alternator impedance value?
Block diagram of Power line communication?
What is dielectric loss?
what is ic 01,ic 06 ?is it types of cooling?
100 MVA 3-phase alternator with earthed neutral has a reactance of 5 ohms per phase. what will be the fault MVA of generator.
why motor range is available 22kv,30kv,37kv,45kv and so on? why motor range is not available 21kv,24,25,26,27kv and so on?
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
